Don’t worry about how to get yourself well prepared your NCSE ns0-194 exam! We will work you out of your NCSE ns0-194 exam with the latest updated NetApp Certified Support Engineer ns0-194 braindumps . We provides the latest real NCSE latest ns0-194 dumps, covering every aspect of ns0-194 exam curriculum.
Visit our site to get more ns0-194 Q and As:https://www.brainitdump.com/ns0-194.html (60 QAs Dumps)
Question 1:
For security reasons, you must track the access of files of a specific folder.
In this scenario, what should you do to accomplish this task from the storage side?
A. Implement a Vscan solution.
B. Use a cron job to save the audit log.
C. Use role-based access control to track access.
D. Implement an FPolicy solution.
Correct Answer: D
Reference: https://library.netapp.com/ecmdocs/ECMP1196993/html/GUID-07D368C8-F4DD-4F14-9E68-99C63881EBE7.html
Question 2:
You need to provide a customer an action plan to update an ONTAP system after a security bulletin has been issued. In this scenario, how do you accomplish this task?
A. Use the Interoperability Matrix Tool.
B. Review the ONTAP 9 product page.
C. Download the target version and do a pre-check.
D. Use Upgrade Advisor on Active IQ.
Correct Answer: C
Question 3:
What is the minimum number of compute nodes required to run the NetApp Deployment Engine for NetApp HCI?
A. 2
B. 1
C. 3
D. 4
Correct Answer: A
Reference: https://docs.netapp.com/us-en/hci/docs/task_hci_getstarted.html#:~:text=The minimum cluster for NetApp,to all NetApp HCI networks.
Question 4:
Which NetApp technology enables you to perform block-based replication from NetApp Element software to Cloud Volumes ONTAP?
A. SyncMirror
B. SnapMirror
C. Cloud Sync
D. MetroCluster
Correct Answer: B
Question 5:
What are two reasons to use VLANs in a NetApp storage solution? (Choose two.)
A. to isolate UDP traffic from TCP traffic
B. to isolate management traffic from other IP traffic
C. to isolate iSCSI traffic from NAS traffic
D. to isolate FC traffic from other IP traffic
Correct Answer: AC
Question 6:
Which three techniques are used in ONTAP to improve storage efficiencies? (Choose three.)
A. compression
B. encryption
C. compaction
D. ADP
E. thin provisioning
Correct Answer: ACE
Reference: https://cloud.netapp.com/blog/storage-efficiency-success-stories-with-cloud-volumes-ontap
Question 7:
You are working on a fabric MetroCluster. After a site failure, the plex starts to resync automatically to the aggregate mirror of Aggr1. The plex now shows a status of resyncing. During this process, you experience a slow resync of the SyncMirror plex.
In this scenario, how do you solve the problem?
A. Add more disks to the aggregate to add more I/O capacity.
B. Destroy and re-create plex, then run a baseline sync.
C. Tune the resync speed by adding a QoS policy and limit the concurrent I/O to the aggregate.
D. Tune the resync speed using the storage raid-options command.
Correct Answer: C
Reference: https://library.netapp.com/ecmdocs/ECMP1368831/html/GUID-F3E1536B-0C54-4D4F-B985-3D839032234D.html
Question 8:
Which type of MetroCluster is shown in the exhibit?
A. 2-node stretch MetroCluster
B. 4-node MetroCluster IP
C. 4-node Fabric-Attached MetroCluster
D. 4-node stretch MetroCluster
Correct Answer: C
Question 9:
You have an ONTAP 2-node cluster. You run a read/write test workload against an SMB share, and it is slower than you expected. You run the same test again, but this time you monitor the storage using a QoS command.
Referring to the exhibit, what is the problem?
A. There is a disk bottleneck.
B. An HA interconnect problem is present.
C. The SMB read sizes should be increased.
D. The NVRAM needs to be replaced.
Correct Answer: B
Question 10:
You have a 4-node MetroCluster system. A node needs to be taken down for maintenance, but all data needs to remain online. In this scenario, what should you do to bring down a single node?
A. Perform an HA takeover of the node.
B. Perform a MetroCluster switchover.
C. Disable HA on each side of the MetroCluster.
D. Perform an aggregate relocation of the CFO aggregates on the node.
Correct Answer: A
Question 11:
What are two conditions that would cause writes in memory to be written to disk? (Choose two.)
A. The NVRAM (NVLog) fills up.
B. A user presses “Save”.
C. Drive capacity becomes available.
D. A Snapshot copy is taken.
Correct Answer: AB
Question 12:
You received the “CLUSTER ERROR: DISK/SHELF COUNT MISMATCH” AutoSupport message from an ONTAP cluster.
When analyzing this message, which two should be inspected? (Choose two.)
A. drive paths
B. IOM firmware
C. drive firmware
D. SAS cabling
Correct Answer: AC
Question 13:
Which two statements describe ONTAP NVRAM? (Choose two.)
A. ONTAP NVRAM is used as read cache.
B. ONTAP NVRAM stores uncommitted writes.
C. ONTAP NVRAM is used as write cache.
D. ONTAP NVRAM is battery backed.
Correct Answer: BC
Reference: https://kb.netapp.com/Advice_and_Troubleshooting/Data_Storage_Software/ONTAP_OS/FAQ:_Consistency_Point
Question 14:
When using NetApp Volume Encryption (NVE) which type of server is needed to keep encryption keys separate from encrypted data?
A. KMIP
B. RADIUS
C. TLS
D. TKIP
Correct Answer: A
Reference: http://docs.netapp.com/ontap-9/index.jsp?topic=/com.netapp.doc.pow-nve/GUID-EAD13D8E-0219-45B6-A2C6-B25B76C9CA1A.html
Question 15:
A customer will need to perform an upgrade from 9.0 to 9.4.
Which feature of ONTAP enables nondisruptive hardware maintenance for this upgrade?
A. aggregate relocation
B. FlexVol
C. FlexGroup
D. RAID-TEC
Correct Answer: A
Reference: https://docs.netapp.com/ontap-9/index.jsp?topic=/com.netapp.doc.dot-cm-hacg/GUID-519510F4-AE00-4859-9706-217553D05FB9.html
Visit our site to get more ns0-194 Q and As:https://www.brainitdump.com/ns0-194.html (60 QAs Dumps)
