Tens of thousands of competitors, pages of hard questions and unsatisfied exam preparation situations… Do not worried about all those annoying things! We, help you with your NSE4 NSE4_FGT-7.0 Fortinet NSE 4 – FortiOS 7.0 exam. We will assist you clear the NSE4_FGT-7.0 exam with NSE4 NSE4_FGT-7.0 braindumps. We NSE4_FGT-7.0 vce are the most comprehensive ones.
Visit our site to get more NSE4_FGT-7.0 Q and As:https://www.passitdump.com/nse4_fgt-7-0.html (166 QAs Dumps)
Question 1:
Which three statements about a flow-based antivirus profile are correct? (Choose three.)
A. IPS engine handles the process as a standalone.
B. FortiGate buffers the whole file but transmits to the client simultaneously.
C. If the virus is detected, the last packet is delivered to the client.
D. Optimized performance compared to proxy-based inspection.
E. Flow-based inspection uses a hybrid of scanning modes available in proxy-based inspection.
Correct Answer: CDE
Question 2:
Refer to the exhibit.
Which contains a session list output. Based on the information shown in the exhibit, which statement is true?
A. Destination NAT is disabled in the firewall policy.
B. One-to-one NAT IP pool is used in the firewall policy.
C. Overload NAT IP pool is used in the firewall policy.
D. Port block allocation IP pool is used in the firewall policy.
Correct Answer: A
Question 3:
Which two statements are correct regarding FortiGate FSSO agentless polling mode? (Choose two.)
A. FortiGate points the collector agent to use a remote LDAP server.
B. FortiGate uses the AD server as the collector agent.
C. FortiGate uses the SMB protocol to read the event viewer logs from the DCs.
D. FortiGate queries AD by using the LDAP to retrieve user group information.
Correct Answer: CD
Question 4:
Which three options are the remote log storage options you can configure on FortiGate? (Choose three.)
A. FortiCache
B. FortiSIEM
C. FortiAnalyzer
D. FortiSandbox
E. FortiCloud
Correct Answer: BCD
Question 5:
Refer to the exhibit.
The exhibit contains a network diagram, virtual IP, IP pool, and firewall policies configuration. The WAN (port1) interface has the IP address 10.200.1.1/24. The LAN (port3) interface has the IP address 10 .0.1.254. /24. The first firewall policy has NAT enabled using IP Pool. The second firewall policy is configured with a VIP as the destination address. Which IP address will be used to source NAT the internet traffic coming from a workstation with the IP address 10.0.1.10?
A. 10.200.1.1
B. 10.200.3.1
C. 10.200.1.100
D. 10.200.1.10
Correct Answer: A
Question 6:
Refer to the exhibits to view the firewall policy (Exhibit A) and the antivirus profile (Exhibit B).
Which statement is correct if a user is unable to receive a block replacement message when downloading an infected file for the first time?
A. The firewall policy performs the full content inspection on the file.
B. The flow-based inspection is used, which resets the last packet to the user.
C. The volume of traffic being inspected is too high for this model of FortiGate.
D. The intrusion prevention security profile needs to be enabled when using flow-based inspection mode.
Correct Answer: A
Question 7:
Which two statements about antivirus scanning mode are true? (Choose two.)
A. In proxy-based inspection mode, files bigger than the buffer size are scanned.
B. In flow-based inspection mode. FortiGate buffers the file, but also simultaneously transmits it to the client.
C. In proxy-based inspection mode, antivirus scanning buffers the whole file for scanning, before sending it to the client.
D. In flow-based inspection mode, files bigger than the buffer size are scanned.
Correct Answer: CD
Question 8:
Refer to the exhibit.
Given the security fabric topology shown in the exhibit, which two statements are true? (Choose two.)
A. There are five devices that are part of the security fabric.
B. Device detection is disabled on all FortiGate devices.
C. This security fabric topology is a logical topology view.
D. There are 19 security recommendations for the security fabric.
Correct Answer: BC
Question 9:
Refer to the exhibit.
Which contains a network diagram and routing table output.
The Student is unable to access Webserver.
What is the cause of the problem and what is the solution for the problem?
A. The first packet sent from Student failed the RPF check. This issue can be resolved by adding a static route to 10.0.4.0/24 through wan1.
B. The first reply packet for Student failed the RPF check. This issue can be resolved by adding a static route to 10.0.4.0/24 through wan1.
C. The first reply packet for Student failed the RPF check. This issue can be resolved by adding a static route to 203.0.114.24/32 through port3.
D. The first packet sent from Student failed the RPF check. This issue can be resolved by adding a static route to 203.0.114.24/32 through port3.
Correct Answer: C
Question 10:
Why does FortiGate Keep TCP sessions in the session table for several seconds, even after both sides (client and server) have terminated the session?
A. To allow for out-of-order packets that could arrive after the FIN/ACK packets
B. To finish any inspection operations
C. To remove the NAT operation
D. To generate logs
Correct Answer: B
Question 11:
Which two statements ate true about the Security Fabric rating? (Choose two.)
A. It provides executive summaries of the four largest areas of security focus.
B. Many of the security issues can be fixed immediately by click ng Apply where available.
C. The Security Fabric rating must be run on the root FortiGate device in the Security Fabric.
D. The Security Fabric rating is a free service that comes bundled with alt FortiGate devices.
Correct Answer: AC
Question 12:
Which two settings can be separately configured per VDOM on a FortiGate device? (Choose two.)
A. System time
B. FortiGuaid update servers
C. Operating mode
D. NGFW mode
Correct Answer: AD
Question 13:
An administrator Is configuring an IPsec VPN between site A and site B. The Remote Gateway setting in
both sites has been configured as Static IP Address. For site the local quick mode selector is
192.160.1.0/24 and the remote quick mode selector is 192.168.2.0/24.
Which subnet must the administrator configure for the local quick mode selector for site B?
A. 192.168.1.0/24
B. 192.168.0.0/24
C. 192.168.2.0/24
D. 192.168.3.0/24
Correct Answer: B
Question 14:
An administrator does not want to report the logon events of service accounts to FortiGate. What setting on the collector agent is required to achieve this?
A. Add the support of NTLM authentication.
B. Add user accounts to Active Directory (AD).
C. Add user accounts to the FortiGate group fitter.
D. Add user accounts to the Ignore User List.
Correct Answer: C
Question 15:
Refer to the exhibits.
The exhibits show the SSL and authentication policy (Exhibit A) and the security policy (Exhibit B) tor Facebook. Users are given access to the Facebook web application. They can play video content hosted on Facebook but they are unable to leave reactions on videos or other types of posts. Which part of the policy configuration must you change to resolve the issue?
A. The SSL inspection needs to be a deep content inspection.
B. Force access to Facebook using the HTTP service.
C. Additional application signatures are required to add to the security policy.
D. Add Facebook in the URL category in the security policy.
Correct Answer: A
Visit our site to get more NSE4_FGT-7.0 Q and As:https://www.passitdump.com/nse4_fgt-7-0.html (166 QAs Dumps)
